Prepared by Prof. Dr. Zeinab Attia Nagdy, Full-time Research Head, Central Laboratory for Aquaculture Research
¤ Theoretically, there are several ways to reduce ammonia concentration, but most of them are impractical for large fishponds.
□ Some Methods to Reduce Ammonia Concentration
Stopping feeding or reducing the feeding rate, increasing aeration, adding lime, fertilizing with phosphorus, reducing pond depth, increasing pond depth, and adding certain bacteria.
□ Performance and Effectiveness Evaluation for Each Method
¤¤ Stop feeding or reduce the feeding rate, as the primary source of nearly all ammonia in fishponds is the protein in the feed. When feed protein is completely broken down (metabolized), ammonia is produced within the fish and excreted through the gills into the pond water.
However, this approach depends on whether you want to control it in the short term (days) or the long term (weeks or months).
– In the short term, sharp reductions in the feeding rate have no direct effect on ammonia concentration.
The environmental reason behind this is based on the complex movement of large amounts of nitrogen from one of the pond ecosystem’s many components to another, which takes a long time.
– To reduce long-term risks by adjusting both the feeding rate and the feed protein level.
¤¤ Increase Aeration
The toxic form of ammonia (NH3) is a dissolved gas, so some fish farmers believe that aerating the pond is a way to get rid of ammonia because it accelerates the diffusion of ammonia gas from the pond water into the air. However,
research has proven that aeration is ineffective in reducing ammonia concentration because the volume of water affected by aerators is very small compared to the total volume of the pond,
and because the concentration of ammonia gas in the water is generally low (especially in the morning). Intensive aeration may actually increase ammonia concentration by stirring up pond sediments.
¤¤ Add Lime
It has long been believed that disinfecting ponds with lime reduces ammonia concentrations. In fact, using liming agents such as hydrated lime or quicklime can make a potentially bad situation much worse by causing a sudden and large increase in pH.
Increase pH
An increase in pH shifts ammonia toward the form that is toxic to fish. In addition, calcium in lime can react with soluble phosphorus, removing it from the water and making it unavailable to algae.
¤¤ Fertilize with Phosphorus
Algae absorb most of the ammonia excreted by fish, so anything that increases algal growth will increase ammonia absorption. This fact is the basis for the idea of fertilizing ponds with phosphorus fertilizers to reduce ammonia levels.
However, under “normal” pond conditions, algal blooms in fishponds are extremely dense, and the algal growth rate is limited by light availability,
not nutrients such as phosphorus or nitrogen. Therefore, adding phosphorus does nothing to reduce ammonia concentration because algae are already growing as fast as possible under the prevailing conditions.
– The highest ammonia concentrations in fishponds occur after an algal bloom collapses.
Fertilization, especially with phosphorus, may accelerate the reestablishment of the bloom, but most ponds contain plenty of dissolved phosphorus (and other nutrients) to support a bloom and do not need more.
¤¤ Reduce Pond Depth
Theoretically, dense algal blooms in shallow ponds remove ammonia more effectively than the same dense blooms in deep ponds.
However, in the final analysis, there are probably more benefits associated with deep ponds (for example, easier fish harvesting, water conservation, more stable temperatures, and a reduced effect of sedimentation on the time interval between renovation operations).
¤¤ Increase Pond Depth
Deep ponds contain more water than shallow ponds. Therefore, at a given feeding rate,
deep ponds should have lower ammonia concentrations because there is more water to dilute the ammonia excreted by the fish.
In reality, deep ponds usually do not have enough water to dilute ammonia significantly compared to the large amounts of ammonia in the continuous flow between the various biotic and abiotic processes in ponds.
Moreover, deep ponds are more susceptible to stratification, and the bottom layer of pond water (the lower layer) can become rich in ammonia and depleted of dissolved oxygen. When this water layer mixes with surface water in a “turnover,” it may cause serious water quality problems.
¤ Add Bacterial Additives
Common aquatic bacteria are an essential part of the continuous ammonia cycle in the pond ecosystem.
Some people believe that ammonia accumulates in ponds due to the presence of the wrong type or an insufficient number of bacteria, and this is not certain.
Standard aquarium management creates very favorable conditions for bacterial growth. Bacterial growth and activity are limited by the availability of oxygen and temperature rather than the number of bacterial cells. Also,
the most abundant type of bacteria in many additives (and in aquarium water and sediments) is responsible for breaking down organic matter. Therefore, if bacterial amendments accelerate the breakdown of organic matter, the ammonia concentration will actually increase, not decrease.
– Even the type of bacteria in additives that oxidizes ammonia to nitrate: adding it will not quickly reduce the ammonia concentration because the bacteria need to grow for several weeks before there is a large enough number to impact the ammonia level.
The Key to Ammonia Management in Fish Aquariums
In general, a high ammonia concentration often indicates that nitrite concentrations may rise soon. In this case, farmers should focus on protecting fish from nitrite poisoning by adding salt, rather than trying to manage the ammonia problem.
It may also be necessary to exercise extreme caution after an algae crash. Usually, the ammonia concentration drops again once the bloom re-establishes.
□ The key to managing ammonia is to use fish-farming practices that reduce the likelihood of such problems occurring. This means stocking fish at a reasonable density, harvesting as often as possible to prevent the standing crop from becoming too large, and using good feeding practices that maximize feed conversion.


Latest video
تابع معنا تحليل قراءة الصحف اليومية مع الكاتب الصحفي Hany Sallam عبر